Complete the Job - 70 XT1600 Operator’s Manual
Rinse Equipment
CMW
Rinse Equipment
1. Spray water onto equipment to remove dirt and mud.
2. Open hood and remove debris from inside of unit.
3. Remove mud from track sprockets and rollers.
Disconnect Attachment
1. Lower attachment to the ground.
2. Turn off engine.
3. Disengage lock pins by lifting handles up.
4. Disconnect hydraulic hoses, if used.
5. Start engine.
6. Tilt mount plate forward and back unit away from attachment.
Stow Tools
Make sure all tools and accessories are loaded and properly secured on trailer.
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged.
Wipe down instead.
Note: If unit is equipped with hydraulic attachment lock option, move attachment lock switch to
the unlock position. For information on this control, see page 21.
To Next Page
Loading...