Operation Overview - 38 XT855 Operator’s Manual
Planning
CMW
Planning
1. Gather information about jobsite. See page 40.
2. Inspect jobsite. See page 41.
3. Classify jobsite. See page 42.
4. Check supplies and prepare equipment. See page 44.
5. Load unit onto trailer. See page 52.
Using Tool Carrier Mode
1. Unload from trailer. See page 57.
2. Drive to job. See page 47.
3. Connect front attachment. See page 70.
4. Operate attachment. See page 72 and attachment operator’s manual.
5. Disconnect front attachment. See page 70.
Using Excavator Mode
1. Unload from trailer. See page 52.
2. Drive to job. See page 47.
3. Dig trench or hole. See page 65.
Leaving Jobsite
1. Rinse unit and stow tools. See page 74.
2. Load unit onto trailer. See page 52.
To Next Page
Loading...
