XT855 Operator’s Manual Transport - 53
Haul
CMW
Without Tiedown Kit
1. Start engine.
2. Fasten seat belt and swivel seat to face the tool carrier.
3. Ensure work mode switch is in tool carrier mode.
4. Raise mount plate off ground.
5. Move unit to rear of trailer and align with ramps.
6. Slow engine speed and slowly drive unit onto trailer.
7. Once unit is correctly positioned on trailer, lower mount plate to trailer floor.
8. Lower excavator bucket to trailer deck and/or attach tiedown.
9. Stop engine.
10. Attach tiedowns where indicated on page 54.
IMPORTANT: Disconnect and stow front attachment before loading unit.
To Next Page
Loading...
