DITEC 94 - Application Example: Come Selector; Come Selector Integration

@ 7. EXAMPLE OF APPLICATION WITH COME SELECTOR
The automation opens with Radar's controls 1-3A, 1-3B, it closes automatically according to the function chosen on the se-
lector.
It carries out the security function over the passage way by means of Cel photocells,
With selector in STOP position every normal and emergency working is cut off,
Contact 1-4 can be connected to a button to achieve a closing control.
As contact 1-8 is independent from the selector, it will be necessary to make a jumper if it is not used,
As contact 1-9 is to be considered in series to the STOP, set by the selector, it will be necessary to make a jumper if it is not
used.
Contact 1-29 can be used to RESET the electronic control panel
94
DOPEN
II RESET
O
POWER DIP Rl TC
GP ALARM Iilfil """ ~
29 0 • g;}l!!JO 0
280 SA
270 •
9 0 ct--<=-
80
40 fJ\
3BO~
3AD
2
1
OPEN III
It IAI .] I!!:!l
Radar B
n ~4~
Radar A
n ~4~
P2
R2
DIR
-ID IlI
SA
'ETY ---~~III
I~;~ I!!:!lB BE1i:J~~~ I!!:!l
li1. : gJ]COMgJ][!]~FVAVCRP IP
J=
COME
14