DITEC E2J User Manual

10
IP1935EN  2010-07-19
10. TROUBLESHOOTING
Problem Possible causes Remedy
The automation does not
open or close.
No power.
(POWER led off).
ChecN that the control panel is powe-
red correctl\.
Short circuited accessories.
(POWER led off).
Disconnect all accessories from termi-
nals 0-1 (voltaJe must be 24 V=) and
reconnect one at a time.
Blown line fuse.
(POWER led off).
Replace F1 fuse.
Safet\ contacts are open.
(SA led on).
ChecN that the safet\ contacts are clo-
sed correctl\ (N.C.).
The remote control does not worN. ChecN the correct memori]ation of the
transmitters on the incorporated radio.
If there is a fault with the radio receiver
that is incorporated in the control panel,
the radio control code can be read b\
removinJ the storaJe module.
The automation opens but
does not close.
Safet\ contacts are open.
(SA led on).
ChecN that the safet\ contacts are clo-
sed correctl\ (N.C.).
Photocells are activated.
(SA led on).
ChecN that the photocells are clean and
operatinJ correctl\.
The automatic closinJ does not worN. ChecN that the TC trimmer is not set at
the maximum.
The automation is ver\
weaN and does not invert
the movement.
The motor’s condenser has an incor-
rect capacit\ value.
Replace the motor’s condenser.
External safet\ devices not
activatinJ.
Incorrect connections between the
photocells and the control panel.
Connect N.C. safet
\ devices toJether in
series and remove an\ bridJes on the
control panel terminal board.
The remote control has li-
mited ranJe and does not
worN with the automation
movinJ.
The radio transmission is impeded b\
metal structures and reinforced con-
crete walls.
Install the antenna outside. Substitute
the transmitter batteries.

DITEC E2J Specifications

General

Brand	DITEC
Model	E2J
Category	Gate Opener
Language	English