4
IP1935EN 2010-07-19
2. EC DECLARATION OF CONFORMITY
Manufacturer: DITEC S.p.A.
Address: via Mons. Ban¿, 3 21042 Caronno P.lla (VA) - ITALY
declares that the control panel E2 (with receiver 433.92 MH]) is in conformit\ with the provisions of the follow-
inJ EC directives:
R&TTE Directive 1999/5/CE;
EMC Directive 2004/108/CE;
Low VoltaJe Directive 2006/95/CE.
Caronno Pertusella, 19-07-2010 Silvano AnJaroni
(ManaJinJ Director)
3. TECHNICAL DATA
3.1 Applications
4. CONNECTION OF POWER SUPPLY
Fix the control panel permanentl\. Pass the cables alonJ from the lower side of the container.
Before connectinJ the power suppl\, maNe sure the plate data correspond to that of the mains power suppl\.
An omnipolar disconnection switch with minimum contact Japs of 3 mm must be included in the mains suppl\.
ChecN that upstream of the electrical installation there is an adeTuate residual current circuit breaNer and a
suitable overcurrent cutout.
8se a 3x1.5 mm FROR 450/750V t\pe electric cable and connect to the terminals L (brown), N (blue),
(\ellow/Jreen) in the automation.
Secure the cable usinJ a special cable clamp.
MaNe sure there are no sharp edJes that ma\ damaJe the power suppl\ cable.
Connection to the mains power suppl\, in the section outside the automation, is made with independent channels
and separated from the connections to the control and safet\ devices.
E2 E2J
Power supply 230 V~ / 50 H] 120 V~ / 60 H]
F1 fuse F5A F6,3A
1 motor output 230 V~ / 5 A 120 V~ / 6,3 A
2 motors output 230 V~ / 2 x 2,5 A 120 V~ / 2 x 3,15 A
Accessories power supply 24 V= / 0,5 A
Temperature -20 °C / +55 °C
Degree of protection IP55
Memorizable radio codes 200
Radio frequency 433,92 MH]
i
NOTE: the given operating and performance features can only be guaranteed with the use of DITEC
accessories and safety devices.