Dittmann Caretalk TH1071 - Energy-Saving Mode

Basic functions
26
the blue backlight for the buttons ( ) for fore-
head measurement
6
and (
) for ear measure-
ment
7
will illuminate for approx. 15 seconds. If
you push the button (
) once in standby mode,
the backlight for the buttons (
) for ear measure-
ment and (
) for forehead measurement will
appear for approx. 15 seconds.
If the thermometer is switched off and
you push the button (
), the backlight
of the LCD display will illuminate for
approx.10seconds and the backlight
for the buttons (
) for forehead mea-
surement and (
) for ear measurement
will illuminate for approx.15seconds.
Energy-saving mode
By default, the thermometer is configured to
switch to standby mode approx. 30 – -60 sec-
onds after the last button activity depending
on the respective mode (time, date and room
temperature are shown in alternation). If you
would like the thermometer to turn off com-
pletely after approx. 1 minute, follow the steps
below:
1. In standby mode, hold the SET button
3
down for approx. 2 seconds until the 24 hr in-
dicator starts to blink on the LCD display
1
.
2. Then push the SET button 6 more times
until the LCD indicator briefly appears on
the LCD display and until the ON indicator
flashes right afterwards.
3. If you now push the MEM button
9
, the
OFF indicator will start to blink on the LCD
display.