IC100CX
1592022550 Quick reference guide IC100CX GB rel.1.0 03/03/2008 Page 2 di 39
INDEX
1. General Advices _________________________ 2
2. User Interface ___________________________ 3
3. Remote Keyboard VICX610 ________________ 4
4. Display visualization______________________ 5
5. Silencing the Buzzer______________________ 5
6. First Installing___________________________ 5
7. How to Set the Clock RTC _________________ 5
8. “ Hot Key” Programming __________________ 5
9. Parameters Programming _________________ 6
10. How to Change the Password ______________ 6
11. Start / Stop Chiller or Heat Pump____________ 6
12. Stand- By Function_______________________ 7
13. “menu” Function ________________________ 7
14. Keyboard Functions______________________ 8
15. Black Out_______________________________ 8
16. Installing and Mounting ___________________ 9
17. Electrical Wiring ________________________ 11
18. Alarm Code and Events __________________ 12
19. Connecting Diagram_____________________ 19
20. Parameter Table ________________________ 22
21. Technical Data _________________________ 39
1. GENERAL ADVICES
• Please read this manual before using
• This manual is part of the product and should be kept near the
instrument for easy and quick reference.
• The instrument shall not be used for purposes different from
those described hereunder. It cannot be used as a safety
device.
• Check the application limits before proceeding.
1.1 Safety Precaution
• Check the supply voltage is correct before connecting the
instrument.
• Do not expose to water or moisture: use the controller only
within the operating limits avoiding sudden temperature
changes with high atmospheric humidity to prevent
formation of condensation
• Warning: disconnect all electrical connections before any
kind of maintenance.
• Fit the probe where it is not accessible by the End User. The
instrument must not be opened.
• In case of failure or faulty operation send the instrument
back to the distributor or to “Dixell s.r.l.” (see address) with a
detailed description of the fault.
• Consider the maximum current which can be applied to each
relay (see Technical Data).
• Ensure that the wires for probes, loads and the power supply
are separated and far enough from each other, without
crossing or intertwining.
• In case of applications in industrial environments, the use of
mains filters (our mod. FT1) in parallel with inductive loads
could be useful.
1.2
full Manual
Dixell S.p.A. reserves the right to modify or improve this
manual without prior notice.
The complete manual can be requested at the following
email address.
dixell@dixell.com
To Next Page
Loading...
Need help?
General
