INDEX
1 GENERAL ADVICE 6
2 GENERAL FEATURES 6
2.1 MAIN FUNCTION 6
3 IC200 CX TABLE OF THE FEATURES 8
4 USER INTERFACE 9
4.1 DISPLAY CONFIGURATION 9
4.2 FORCED READ - OUT OF THE TOP AND BOTTOM DISPLAY 11
4.3 ICONS MEANING 12
4.4 MEANING / FUNCTIONNING OF THE BOTTOM DISPLAY LED 13
5 DISPLAY LAYOUT 13
5.1 HOW TO READ THE MEASUREMENT LIST 13
5.2 READ PROBE VALUES OF CIRCUIT 1 OR 2 13
6 DISPLAY INFORMATION 14
6.1 READ THE SET POINT VALUE 14
6.2 MODIFY THE SET POINT 14
6.3 READ THE ACTIVE SETPOINT DURING ENERGY SAVING OR DYNAMIC SETPOINT 14
6.4 DISPLAY VISUALIZATION IN REMOTE OFF 14
6.5 DISPLAY VISUALIZATION IN STD-BY 15
6.6 DISPLAY IN CONDENSING UNIT 15
6.7 KEY FUNCTION 16
6.8 KEY COMBINANTION 16
7 REMOTE TERMINAL 17
8 FIRST INSTALLING 17
8.1 ON BOARD CLOCK (OPTIONAL) 17
8.2 RTC SETUP 17
9 ANALOG AND DIGITAL OUTPUT CONFIGURATION 18
9.1 ANALOG INPUT PB1 - PB2 – PB5 – PB6 18
9.2 ANALOG INPUT CONFIGURATION PB3 - PB4 18
9.3 DIGITAL INPUT CONFIGURATION ID1 – ID18 18
9.4 DIGITAL OUTPUT (RELAY) CONFIGURATION RL1- RL8 19
9.5 ANALOG OUTPUT CONFIGURATION 0 ÷ 10 VOLT (OUT1 E OUT2) 20
9.6 CONFIGURAZIONE N° 2 USCITE ANALOGICHE 0 ÷ 10 VOLT / TAGLIO DI FASE (OUT3 E OUT4) 20
10 PROGRAMMING WITH THE “HOT KEY 64” 21
10.1 DOWNLOAD: HOW TO PROGRAM AN INSTRUMENT WITH A PROGRAMMED “HOT KEY” 21
10.2 UPLOAD: HOW TO PROGRAM A “HOT KEY” WITH THE PARAMETERS OF THE INSTRUMENT 21
11 PROGRAMMING USING THE KEYBOARD 21
11.1 PASSWORD DEFAULT VALUES 21
11.2 ENTER THE PR1 - PR2 - PR3 PROGRAMMING LEVELS 21
11.3 HOW TO CHANGE A PARAMETER VALUE 21
11.4 CHANGE THE PASSWORD VALUE 22
11.5 ENTER THE PROGRAMMING LEVEL PR1 22
11.6 ENTER THE PROGRAMMING LEVEL PR2 22
11.7 ENTER THE PROGRAMMING LEVEL PR3 23
11.8 MOVE A PARAMETER LEVEL FROM PR2 TO PR1 23
11.9 MOVE A PARAMETER FROM PR3 TO PR2 TO PR1 24
11.10 VISIBILITY AND PARAMETER VALUE LOCKED 24
11.11 PROGRAMMING: DIGITAL INPUT AND OUTPUT POLARITY 24
11.12 CHANGE THE POLARITY OF THE DIGITAL INPUTS-OUTPUTS 25
To Next Page
Loading...
Need help?
General
