DJI FPV
User Manual
48
© 2021 DJI All Rights Reserved.
When GPS is available
Flight Limits Goggles Aircraft Status Indicator
Max Altitude
Aircraft's altitude cannot exceed the
specied value
Warning: Height limit reached
Blinks green and red
alternately
Max Radius
Flight distance must be within the
max radius
Warning: Distance limit reached
When GPS is weak
Flight Limits Goggles Aircraft Status Indicator
Max Altitude
Height is restricted to 98 ft (30 m)
when the GPS signal is weak.
Warning: height limit reached.
Blinks red and green
alternately
Max Radius The restrictions on the radius are disabled and warning prompts cannot be received in the goggles.
There will be no altitude limit if the GPS signal becomes weak during ight as long as the GPS signal
display was white or yellow when the aircraft was powered on.
If the aircraft is in a GEO zone and there is a weak or no GPS signal, the aircraft status indicator will
glow red for ve seconds every twelve seconds.
The aircraft can still be controlled if it reaches an altitude or radius limit, but it cannot y any farther.
For safety reasons, do not y close to airports, highways, railway stations, railway lines, city centers,
or other sensitive areas. Only y the aircraft within visual line of sight.
GEO Zones
All GEO zones are listed on the DJI ocial website at https://www.dji.com/ysafe. GEO zones are divided into
dierent categories and include locations such as airports, airelds where manned aircraft operate at low altitudes,
national borders, and sensitive locations such as power plants.
A prompt will appear in the goggles if the aircraft is approaching a GEO zone and the aircraft will be restricted from
ying in the area.
Pre-Flight Checklist
1. Make sure the goggles battery, remote controller, Intelligent Flight Battery, and mobile device are fully charged.
2. Make sure the propellers are mounted correctly and securely.
3. Make sure the Intelligent Flight Battery and goggles battery are properly connected and secure.
4. Make sure the gimbal and camera are functioning normally.
5. Make sure the motors are unobstructed and functioning normally.
6. Make sure that the goggles are functioning normally and display the video transmission.
7. Make sure that the gimbal protector is detached and the camera lens and the Vision System sensors are
clean.
8. Make sure that the goggles antennas are installed securely and the remote controller antenna is lifted.
9. Only use genuine DJI parts or parts certified by DJI. Unauthorized parts or parts from non-DJI certified
manufacturers may cause the system to malfunction and compromise safety.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
