89
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
FPV Camera View
Using FPV Camera View
After tapping Enter Camera View on the homepage of DJI Pilot 2 and nishing the preight check, you
will be directed to FPV camera view by default.
1
2
3
4
5 6 78
9
1. Top Bar: displays the aircraft status, ight mode, signal quality, etc. Refer to the Top Bar section for
more details.
2. Discreet Mode Switch: Tap to turn off the aircraft rear indicators and front indicators, beacons,
auxiliary light, and battery indicators. After enabling Discreet Mode, the auxiliary light will not turn on
during landing, which may present certain risks. Use Discreet Mode with caution.
3. Beacons Switch: Press the L1 button on the remote controller to turn the beacons on or o.
4. Switch to Map View: Press the L3 button on the remote controller to switch to map view.
5. Map View: Users can maximize or minimize the map. The map view supports zooming in and out.
6. Gimbal Camera View: Tap to switch to gimbal camera view. The gimbal camera view supports
zooming in and out.
7. Switch to Gimbal Camera View: Press the R3 button on the remote controller to switch to gimbal
camera view.
8. AR Projection: projects information such as PinPoints, waypoints, and the Home Point in FPV
camera view and gimbal camera view to improve ight perception. Refer to the AR Projection section
for more details.
9. Primary Flight Display (PFD): shows parameters such as attitude, speed, altitude, and wind speed
during a ight. Refer to the Primary Flight Display (PFD) section for more details.
To Next Page
Loading...
Need help?
General
