66
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the inner or outer
bottom corners to start the motors. Once the motors start spinning, release both sticks simultaneously.
Stopping the Motors
The motors can be stopped in two ways:
Method 1: When the aircraft has landed, push the throttle stick down and hold. The motors will stop
after three seconds.
Method 2: When the aircraft has landed, push the throttle stick down, and perform the same CSC used
to start the motors. Release both sticks once the motors have stopped.
1
2
If the motor is started unexpectedly, use CSC to stop motors immediately.
To Next Page
Loading...
