dji MAVIC 3 PRO - FAR Remote ID Compliance; After-Sales Support

DJI Mavic 3 Pro User Manual
114
©
2023 DJI All Rights Reserved.
FAR Remote ID Compliance Information
The aircraft complies with the requirements of 14 CFR Part 89:
• The aircraft automatically broadcasts Remote ID messages from takeo to shut down. An
external device such as a cell phone or tablet is required to be connected as a location
source to DJI mobile devices without an integrated GNSS system
[1]
, and must run the DJI
ight control app such as DJI Fly in the foreground and always allow the DJI ight control app
to obtain its accurate location information. The connected external device must minimally be
one of the following:
1) FCC Certified personal wireless device that uses GPS with SBAS (WAAS) for location
services; or
2) FCC Certied personal wireless device with integrated GNSS.
Also, the external device must be operated in a way that does not interfere with the location
reported and its correlation to the operator location.
• The aircraft automatically initiates a pre-flight self-test (PFST) of the Remote ID system
before takeo and cannot take o if it does not pass the PFST
[2]
. The results of the PFST of
the Remote ID system can be viewed in either a DJI ight control app such as DJI Fly or DJI
goggles.
• The aircraft monitors the Remote ID system functionality from pre-ight to shut down. If the
Remote ID system malfunctions or has a failure, an alarm will be displayed in either a DJI
ight control app such as DJI Fly or DJI goggles.
Footnotes
[1] DJI mobile devices without an integrated GNSS system such as DJI RC-N1, DJI FPV Goggles V2, and DJI
Goggles 2.
[2] The pass criterion for PFST is that the hardware and software of the Remote ID required-data source and
radio transmitter in the Remote ID system are functioning properly.
After-Sales Information
Visit https://www.dji.com/support to learn more about after-sales service policies, repair
services, and support.