dji MAVIC 3 PRO

DJI Mavic 3 Pro User Manual
26
©
2023 DJI All Rights Reserved.
Takeo/Landing Procedures
1. Place the aircraft in an open, at area with the aircraft rear facing towards the user.
2. Power on the remote controller and the aircraft.
3. Launch DJI Fly and enter the camera view.
4. Tap Settings > Safety, and then set the Obstacle Avoidance Action to Bypass or Brake. Make
sure to set an appropriate Max Altitude and RTH Altitude.
5. Wait for the aircraft self-diagnostics to complete. If DJI Fly does not show any irregular
warning, the user can start the motors.
6. Push the throttle stick up slowly to takeo.
7. To land, hover over a level surface and push the throttle stick down to descend.
8. After landing, push the throttle down and hold until the motors stop.
9. Power o the aircraft before the remote controller.
Video Suggestions and Tips
1. The pre-ight checklist is designed to help the user y safely and shoot videos during ight.
Go through the full pre-ight checklist before each ight.
2. Select the desired gimbal operation mode.
3. It is recommended to take photos or record videos when ying in Normal or Cine mode.
4. DO NOT y in bad weather such as on rainy or windy days.
5. Choose the camera settings that best suit your needs.
6. Perform ight tests to establish ight routes and preview scenes.
7. Push the control sticks gently to ensure smooth and stable movement of the aircraft.
• Make sure to place the aircraft on a flat and steady surface before takeoff. DO NOT
launch the aircraft from your palm or while holding it with your hand.