dji MAVIC 3 PRO

DJI Mavic 3 Pro User Manual
80
©
2023 DJI All Rights Reserved.
Flight Pause/RTH Button
Press once to make the aircraft brake and hover in place. Press and hold the button until the
remote controller beeps and starts RTH, the aircraft will return to the last recorded Home Point.
Press this button again to cancel RTH and to regain control of the aircraft.
Customizable Buttons
Go to Settings > Control in DJI Fly to set the functions of the customizable C1 and C2 buttons.
Remote Controller LEDs
Status LED
Blinking Pattern Descriptions
— Solid red Disconnected from the aircraft
Blinking red The battery level of the aircraft is low
— Solid green Connected with the aircraft
Blinking blue The remote controller is linking to an aircraft
— Solid yellow Firmware update failed
— Solid blue Firmware update successful
Blinking yellow The battery level of the remote controller is low
Blinking cyan Control sticks not centered
Customizable
Button C2
Customizable
Button C1