dji MAVIC 3 PRO

DJI Mavic 3 Pro User Manual
56
©
2023 DJI All Rights Reserved.
LED1
LED2
LED3
LED4
Power Button
The battery level LEDs display the power level of the battery during discharging. The
statuses of the LEDs are dened below:
: LED is on : LED is ashing :
LED is o
LED1 LED2 LED3 LED4 Battery Level
88%-100%
76%-87%
63%-75%
51%-62%
38%-50%
26%-37%
13%-25%
0%-12%
Powering On/O
Press the power button once, then press again, and hold for two seconds to power the battery
on or o. The battery level LEDs display the battery level when the aircraft is powered on.
battery cell is detected.
10. Hibernation Mode: the battery switches o after 20 minutes of inactivity to save power. If
the battery level is less than 5%, the battery will enter Hibernation mode after six hours to
prevent over-discharge. In Hibernation mode, the battery level indicators do not illuminate.
Charge the battery to wake it from hibernation.
11. Communication: information about the voltage, capacity, and current of the battery is
transmitted to the aircraft.
• Refer to the Safety Guidelines and the stickers on the battery before use. Users shall
take full responsibility for all operations and usage.
Using the Battery
Checking the Battery Level
Press the power button once to check the battery level.