dji PHANTOM 2 VISION

To Next Page

To Previous Page

This prompt lists all waypoints and their altitudes. The aircraft will fly to each waypoint listed. If there is a difference

in altitude between waypoints, the aircraft will adjust its altitude as it flies between points. When ready, tap “GO” to

begin mission.

Aircraft reacts differently to the “GO” command

：

(1)

(2)

If aircraft is on the ground, the aircraft takes off automatically and ascend 16 feet (5m) then fly to

the first waypoint.

If aircraft is in the air, the aircraft flies to the first waypoint.

Step 4 Executing Flight Mission

The aircraft flies to each waypoint in numerical order. As it flies, swipe back into the DJI Vision app camera GUI to

control camera tilt and capture photos or video. Tap to pause the mission during the flight, and aircraft will

then start hovering. Tap to resume mission. If you wish to regain control of the aircraft, toggle the S1 switch on

remote controller from (Position-1) to either (Position-2) or (Position-3) to discontinue the current

mission.

Step 5 Landing

When all waypoints have been visited, the aircraft will return to its Home point and hover. Regain control of the

aircraft and land it manually. You may also tap button to initiate “Go Home” procedure. Aircraft will abort

current mission, return to Home point and auto land. When the aircraft is landing automatically, users can control

the aircraft’s position and altitude. Users can start the motors to take off immediately after the motors have

stopped following auto landing.

dji PHANTOM 2 VISION - Page 60