Flight
Phantom 4 Pro / Pro+ User Manual
58
©
2017 DJI All Rights Reserved.
3. Hold the aircraft vertically, with nose pointing downward, and rotate it 360 degrees around the center
axis.
If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move your
aircraft to a different location and try again.
DO NOT calibrate the compass near metal objects such as a metal bridge, cars, scaffolding.
If the aircraft status indicators are blinking red and yellow alternately after placing the aircraft on
the ground, the compass has detected magnetic interference. Change your location.
Auto Takeoff and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to use the
auto takeoff feature:
1. Launch the DJI GO 4 app, and enter “Camera” page.
$PNQMFUFBMMTUFQTPOUIFQSFnJHIUDIFDLMJTU
3. Tap“
wBOEDPOmSNUIBUDPOEJUJPOTBSFTBGFGPSnJHIU4MJEFUIFJDPOUPDPOmSNBOEUBLFPGG
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization. The
BJSDSBGUXJMMBVUPNBUJDBMMZIPWFSCFMPXNFUFST*UJTSFDPNNFOEFEUPXBJUVOUJMUIFSFJTTVGmDJFOU
GPS lock before using the Auto Take-off feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use the
auto-landing feature:
1. Tap on
UPFOTVSFUIFMBOEJOHDPOEJUJPOJTJEFBM4MJEFUPDPOmSN
4. Re-calibrate the aircraft if the aircraft status indicators glows blinking red.