dji PHANTOM 4 PRO - Flight Test

Flight
Phantom 4 Pro / Pro+ User Manual
60
©
2017 DJI All Rights Reserved.
6WRSWKH0RWRU0LGÁLJKW
Pull the left stick to the bottom inside corners and press the RTH button at the same time.
Only stop the
PRWRUVPLGñLJKWLQHPHUJHQF\VLWXDWLRQVZKHQGRLQJVRFDQUHGXFHWKHULVNRIGDPDJHRULQMXU\
8IFOUIF"JSDSBGU4UBUVT*OEJDBUPSTCMJOLZFMMPXSBQJEMZEVSJOHnJHIUUIFBJSDSBGUIBTFOUFSFE'BJMTBGF
mode.
A low battery level warning is indicated by the Aircraft Status Indicators blinking red slowly or
SBQJEMZEVSJOHnJHIU
8BUDIPVSWJEFPUVUPSJBMTGPSNPSFnJHIUJOGPSNBUJPO
Video Suggestions and Tips
 (PUISPVHIUIFGVMMQSFnJHIUDIFDLMJTUCFGPSFFBDInJHIU
2. Select the desired gimbal operation mode in the DJI GO 4 app.
 0OMZTIPPUWJEFPXIFOnZJOHJO1NPEF
 "MXBZTnZJOHPPEXFBUIFSBOEBWPJEnZJOHJOSBJOPSIFBWZXJOE
5. Choose the camera settings that suit your needs. Settings include photo format and exposure
compensation.
 1FSGPSNnJHIUUFTUTUPFTUBCMJTInJHIUSPVUFTBOEQSFWJFXTDFOFT
7. Push the control sticks gently to keep the aircraft’s movement smooth and stable.
Flight Test
Takeoff/Landing Procedures
 1MBDFUIFBJSDSBGUJOBOPQFOnBUBSFBXJUIUIFCBUUFSZMFWFMJOEJDBUPSTGBDJOHUPXBSETZPV
2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery.
3. Launch the DJI GO 4 app and enter the Camera page.
4. Wait until the Aircraft Indicators blink green. This means the Home Point is recorded and it is now safe
UPnZ*GUIFZnBTIZFMMPXUIF)PNF1PJOUIBTOPUCFFOSFDPSEFE
5. Push the left stick up slowly to take off or use Auto Takeoff.
6. Shoot photos and videos using the DJI GO 4 app.
7. To land, hover over a level surface and gently pull down on the left stick to descend.
8. After landing, execute the CSC command or hold the left stick at its lowest position until the motors
stop.
 5VSOPGGUIF*OUFMMJHFOU'MJHIU#BUUFSZmSTUUIFOUIF3FNPUF$POUSPMMFS