dji PHANTOM 4 PRO - Page 96

©
2016 DJI All Rights Reserved.
9
5. Ensure the antennas of the remote controller are unfolded and adjusted to the proper position to achieve
optimal transmission quality.
6. Repair or replace the remote controller if damaged. A damaged remote controller antenna will greatly
decrease performance.
7. Linking is required if you wish to replace your remote controller or receiver or add a new remote
controller. Refer to the User Manual for details.
8. Make Sure that you first switch off the aircraft (after it is safe to do so), then switch off the Remote
Controller. Otherwise it may cause the lost of control of the aircraft.
9. Fully charge the battery at least once every three months to maintain battery health.
&DPHUD
To avoid possible serious injury and property damage, observe the following rule:
1. DO NOT block any ventilation holes on the camera as the heat generated may hurt you and damage the
device.
 $IFDLDBNFSBTFUUJOHTCFGPSFVTFUPNBLFTVSFZPVDBOBEKVTUUIFNUPmUZPVSOFFET
2. Test the camera by shooting a few test images and check that it is operating correctly before shooting important
pictures or videos.
3. DO NOT remove the Micro SD card from the camera when it is powered on.
4. Photos or videos cannot be transmitted or copied from the camera if the Intelligent Flight Battery is powered off.
5. Be sure to power off the Intelligent Flight Battery correctly, otherwise your camera parameters will NOT
be saved and any recorded videos may be damaged. NOTE: Regardless of the reason, DJI will not be
responsible for any failure of an image or video to be recorded or having been recorded in a way that is not
machine readable.
*LPEDO
1. Precision elements in the gimbal may be damaged in a collision or impact, which may cause the gimbal to
function abnormally.
2. DO NOT apply external force to the gimbal after the gimbal is powered on.
3. DO NOT add any payloads to the gimbal, as this may cause the gimbal to function abnormally or even lead to
motor damage.
4. Remove the gimbal clamp before powering on the gimbal. Re-install the gimbal clamp to secure the gimbal’s
position if you are going to store the aircraft for an extended period.
&RPSDVV
To avoid possible serious injury and property damage, observe the following rule: