DKC SMALLT1 - Installation Instructions; Safety Regulations and Warnings

59
3. Make sure that the ordered model matches the information on the label on
the back panel.
4. In case of damage or lack of accessories, contact the distributor
immediately.
3.4 Installation instructions
1. Ensure that the UPS is installed in a place protected from water, flammable
gases, corrosive substances and any other substances that affect the
performance of the UPS.
2. The UPS must be installed with minimum distance from the front and rear
panels (15 cm) to ensure proper ventilation.
3. If the UPS was stored in a very humid room or at a low temperature, it is
necessary to wait before starting-up until the device dries both inside and
outside.
4. If case of any failure, please refer to the “Troubleshooting” section.
3.5 Safety regulations and warnings
Injury hazard due to electric shock!
Always respect all the safety instructions and, in particular:
 any work on the unit must be carried out by qualified personnel;
 internal components can only be accessed after disconnecting the device
from supply sources;
 always use protective devices designed for each type of activity;
 the instructions contained in the manuals must be strictly followed.
Injury hazard due to device failure
Potentially hazardous situations may arise in case of UPS failure.
 Do not use the device if visibly damaged;