16
The last set temperature is displayed once the instrument is shutdown and
restarted.
4.1.1 EXTERNAL SENSOR INSTALLATION
The external temperature sensor PT1000 is the manufacturer’s standard
accessory
Install the sensor support on the instrument.
Connect the external sensor in the port provided at the back of the unit.
If the sensor is plugged in, “Probe” will be shown on the digital display indicating
the sensor operation.
Fix sensor on the support and adjust its position.
Put the External sensor probe into the vessel on the hotplate.
If any abnormal situation is detected, the heating mode will automatically shut
down. Then please do the following:
- Turn off the power supply,
- Ensure the external temperature controller stay in the heating samples
- Open the power supply, to set the target temperature and heating function
If the instrument cannot work again, please contact the manufacturers/suppliers.
Магнитная мешалка с подогревом - руководство по
эксплуатации
Диаэм - официальный дилер продукции DLAB в России;
тел.: (495) 745-0508, info@dia-m.ru, www.dia-m.ru
To Next Page
Loading...
