17
4.2. Stirring（hotplate stirrer/stirrer）
Instrument adopts closed loop control motor, motor drive mechanism to the
permanent magnets, and can set the motor speed through speed control knob
Set the target stirring speed and start stirring:
Set the target speed by rotating the speed control knob slowly to desired setting.
The set value is confirmed and stirring is switched ON by pushing the stirring
control knob.
The LED displays the target speed value on the right-hand side during stirring.
The stirring function is switched OFF by pushing the same stirring control knob
again.
When both heating and stirring are switched ON and those above operations are
done, the LCD will shift to the speed value and come back to the temperature value
in about 5 seconds.
5. Maintenance and Cleaning
Proper maintenance can keep instruments working properly and lengthen its
lifetime.
Please keep the instrument in dry and clean surface.
Please do not connect the power supply before the surface dry.
Магнитная мешалка с подогревом - руководство по
эксплуатации
Диаэм - официальный дилер продукции DLAB в России;
тел.: (495) 745-0508, info@dia-m.ru, www.dia-m.ru
To Next Page
Loading...
