DMP Electronics 263LTE-V5 Programming Options

Digital Monitoring Products Wireless Programming Options
4
ZONE INFORMATION
Wireless Programming Options Digital Monitoring Products
5
ZONE INFORMATION
16.11.5
BUTTON:
TOP BTM LFT RGT
Key Fob Button Selection (Four Buttons)
This prompt only displays if the key fob being programmed is a four-button
model. Press the Select key under the key fob button to program. The
following list identies the default button assignments:
TOP Arming with no areas assigned
BTM Disarming with no areas assigned
LFT Panic Alarm (PN) with no output assigned
RGT Arming with Area 1 assigned
16.11.6
BUTTON:
TOP BTM
Key Fob Button Selection (Two Buttons)
This prompt only displays if the key fob being programmed is a two-button
model. Press the Select key under the key fob button to program. The
following list identies the default button assignments:
TOP Arming with no areas assigned
BTM Disarming with no areas assigned
16.11.7
BUTTON ACTION
yyy: XXXXXXXX
Button Action
This option species the Button Action for an individual key fob button. The
default action for the button selected is displayed. Press any Select key to
display the Button Action options. To view more options press the COMMAND
key.
yyy = the name of the button being programmed (TOP, BTM, LFT, RGT).
BUTTON ACTION
ARM DIS TGL STA
ARM (Arm) - Arms selected areas and force arms bad zones.
DIS (Disarm) - Disarms selected areas.
TGL (Toggle Arm) - Toggles arm/disarm for selected areas and force arms bad
zones when arming.
STA (Status) - Causes the key fob LED to indicate the arm/disarm status of the
system.
BUTTON ACTION
PN PN2 EM EM2
PN (Panic) - Triggers a Panic zone type alarm with no restoral.
PN2 (Panic 2) - Triggers a Panic zone type alarm with no restoral when pressed
simultaneously with any other Panic 2 button. No action occurs when pressed
alone.
EM (Emerg) - Triggers an Emergency zone type alarm with no restoral.
EM2 (Emerg 2) - Triggers an Emergency zone type alarm with no restoral when
pressed simultaneously with any other Emergency 2 button. No action occurs
when pressed alone.
BUTTON ACTION
OUT RST UN
OUT (Output) - Causes an output to turn on steady, pulse, momentary, toggle or
off.
RST (Sensor Reset) - Causes the panel to perform a standard Sensor Reset.
UN (Unused) - The button is not used and performs no action.
16.11.8
BUTTON
PRESS TIME: XXXXX
Button Press Time
This option species the amount of time (SHORT or LONG) the user must press
the button before the key fob sends a message to the wireless receiver. The
default press time displays. Press any Select key to set the Button Press Time
for Arm, Disarm, Toggle, Status, Output, and Sensor Reset.
Note: The Button Press Time is not programmable on Panic (PN or PN2),
Emergency (EM or EM2) or Unused (UN) zones. For those zones the button press
time is always two (2) seconds.
PRESS TIME:
SHORT LONG
SHORT - Press the button for one-half (1/2) second to send the message to the
wireless receiver.
LONG - Press the button for two (2) seconds to send the message to the wireless
receiver.

DMP Electronics 263LTE-V5 Specifications

General

Brand	DMP Electronics
Model	263LTE-V5
Category	Control Panel
Language	English