DMP Electronics XR500 User Manual

Appendix F XR500/XR100 User’s Guide 65
In Touch™ Text Messaging Commands
Your system may be programmed to allow simple text messages to
be sent to the security system to perform basic user operations.
By texting a message from your cell phone or PDA, the following
actions can be performed: Arm/Disarm, Cancel Alarm, turn
Outputs On/Off, and check Armed Status.
The user that is texting commands to the system must have
the authority to perform the commands as if it occurred at the
keypad. The cell phone number and user numbers are setup during
programming.
After programming is completed, you will receive a welcome
message text from the panel. Write down the phone number that
the message comes from. This will be the number you use to text
user operations to the system.
Note: When texting commands listed below, the commands can be
either upper or lowercase.
A list of In Touch™ SMS Text commands can be obtained by texting
“help” to the system phone number. Store this number in your cell
phone and write the number on the Quick Reference Wallet Card
located at the back of this manual.
Arming All Areas with Text Message Commands
1. Text message your system panel with the following
command:
• ARM, AWAY, or ALL: To arm all areas, depending on your
system
Arming Partial Areas with Text Commands
1. Text message your system panel with the following
command:
• SLEEP: To arm the perimeter and interior of a Home/
Sleep/Away system.
• HOME: To arm just the perimeter of a Home/Away/
Sleep system.
• PERIM: To arm the perimeter of an All/Perimeter system.
• ARM“AreaNumber”orARM“AreaName”:Toarmspecic
areas of an Area system.
The NAME should identify the area name. The NUMBER should
identify the area number. Names and numbers can be mixed. A
comma should be used to separate areas. If only ARM is sent, all
areas are armed.
If the system is already armed, you can arm it again only if you are
arming more areas than were originally armed.
Disarming All Areas with Text Message Commands
1. Text message your system panel with the following
command:
• DISARM: To disarm all areas.
Disarming Partial Areas with Text Message Commands
1. Text message your Area system panel with the following
command:
• DISARM “Area Number” or DISARM “Area Name”: To
disarmspecicareas of an Area system.
The NAME should identify the area name. The NUMBER should
identify the area number. Names and numbers can be mixed. A
comma should separate the areas. If only DISARM is sent, all areas
will be disarmed.
If the system is already disarmed, you will receive a message
saying the system is already disarmed.

DMP Electronics XR500 Specifications

General

Brand	DMP Electronics
Model	XR500
Category	Security System
Language	English