Appendix F XR500/XR100 User’s Guide 67
Q. What do I do if I want to be in the building past the scheduled
closing (arming) time?
A. If your system is programmed for closing check, the keypad
emits a steady tone prior to the system arming. During this tone,
press any Select key to display ENTER CODE: . Enter your user
code and press COMMAND.
The keypad now displays 2HR 4HR 6HR 8HR. Select the number
of hours to extend the schedule. If the system is not armed by
the scheduled closing time, a Late to Close report is sent to the
central station. If the schedule is extended, a Schedule Change
report may be sent to the central station.
Frequently Asked Questions
This section attempts to answer questions you might have regarding
system operation.
Q. If I bypass an exit delay door when I arm the system, will I get
an alarm if I come through it later?
A. You will not get an alarm from the door because it is bypassed,
but if you happen to walk through a motion detector space or other
armed door inside the premises an alarm activates.
Q. When I arm or disarm my Area system, ALL? NO YES displays.
Does this mean all areas in the system?
A. Selecting YES arms or disarms all areas that are authorized for
your user code.
Q. How do I create a schedule that starts at 8:00 AM on Monday
and ends at 5:00 PM on Friday.
A. In the days of the week display, select MON (Monday). For the
OPENING TIME?, enter 0 + 8 + 0 + 0 AM. For the CLOSING TIME?,
at the MON — : AM PM display, select MON; this scrolls through
the days of the week. Stop at the day you want the schedule to
end. Next, enter 0 + 5 + 0 + 0 PM into the FRI — : AM PM closing
time display. Press COMMAND. Press the Back Arrow key to exit
the User Menu.
This sets the opening time to 8:00 AM Monday and the closing time
to 5:00 PM Friday. You can substitute any other day or time in this
example.
To Next Page
Loading...
Need help?
General
