DNP DP-DS820 - Page 17

14
[DP-DS820/DP-DS820 (A) Printer Driver] Instruction Manual (For Windows 11)
Print Re-try
Specify whether to print data in the printer buffer after a printer error has been cleared.
Print Re-try
Function
Disable
Clear the print data in the printer buffer when a printer error occurs.
You must send the cleared print data again after the error is cleared.
When you use an application with an error recovery function, select
this option.
Enable
Save print data in the printer buffer when an error occurs.
The printing process is restarted from the saved data after the error is
cleared.
Note that if the power is switched off, the data is not saved.
Depending on the printer error, print data in the print buffer will be cleared, regardless of the Print
Re-try setting.
The following section shows the operation for each Print Re-try setting by error.
Error content
When Print Re-try is disabled
When Print Re-try is enabled
Paper end
You must send the unprinted
image data again after the error
is cleared.
The printing process is restarted
from the data saved in the printer
buffer after the error is cleared.
When the paper initialization
operation is to be carried out,
printing occurs afterwards.
Ribbon end
Door open
No scrap box
Paper jam
To prevent the occurrence of an error, printing will not be restarted,
regardless of the Print Re-try function setting.
After the printer stops due to an error, follow the User Guide of the
printer to eliminate the cause of the paper or ribbon error.
You must send the unprinted image data again after the error is
cleared.
Ribbon error
Paper size setting error
System error
Because the printer must be switched on and off to clear the error,
the print data in the printer buffer is cleared regardless of the Print
Re-try setting.
After the printer has restarted, you must send the unprinted image
data again.
･Data error
･Head voltage error
･Head position error
･Power supply fan
stopped
･Cutter error
･Head temperature
error
･Media temperature
error
･RFID module error
High density mode
Enables or disables high density mode.
This function is valid only when Print Quality is “High-quality”.
High density mode
Function
Disable
Prints with normal density.
Enable
Prints with an optical density higher than the maximum density. (*1)
*1: Printing time increases over printing with normal density, and the Rewind Print function is also
disabled.