30 31
Dogtra 1900X uses a lithium polymer battery. If the light
is red, the device does not turn on, or the system does not
stay on when you press the button, recharge the device.
NOTE 1: Use only Dogtra approved batteries, chargers
and accessories with the Dogtra e-collar. This will prevent
any damage that may occur if you try to use a different
charger.
Note 2: The device will be partially charged when leaving
the Dogtra facility. When you receive the system, be sure
to give it an initial charge of 2 hours before using it for the
first time in an area away from flammable materials.
Note 3: When the charger is not in use, unplug it from the
power source. If the device will be stored unused for more
than 3 months, fully charge the battery.
8. BATTERY CHARGE
Two- Dog Unit Only
To charge your system, follow the steps below:
1. Open the rubber plug on the battery charging port and
connect the charging cable.
2. Connect the charger to a 120V wall outlet or, if using
an automatic charger, to a cigarette lighter specifically
designed for lithium polymer batteries (in Europe, use
a 220V European charger). When connected properly,
all lights will glow red and the device will automatically
turn off during the charging process. After the device is
fully charged and unplugged from the battery cable, the
device must be turned on again before use.
3. The lithium polymer battery is fully charged within
2 hours. The light stays red while charging and turns
green when the device is fully charged.
4. After charging, cover the battery charging socket with a
rubber plug.
Recharging is required in the following cases:
•The LED on the transmitter or receiver is red.
•The LED on the transmitter or receiver does not light.
• A low-battery sound occurs when the transmitter or
receiver is powered off.
Charger Info
Manufacturer: E-SUN
Manufacturing country: CHINA
Model name: MKC-0502500VT
INPUT: 100-240V~50/60Hz 0.4A
OUTPUT: 5V 2500mA
To Next Page
Loading...
