Dogtra 1900X - General Training Tips

34 35
than 12 seconds, the receiver will automatically stop
stimulation.
6. Turn the rheostat dial on the transmitter clockwise and
then counterclockwise. The test light shines brighter at
higher stimulus levels and dimmer at lower levels.
Note: The test light may not be visible if the intensity
level is set below level ten.
GENERAL TRAINING TIPS
Your dog must know some basic obedience commands
before beginning training with the 1900X. A dog learns
by first being shown a command, followed by lots of
repetition over an extended period. As the dog becomes
proficient at these commands, the trainer can introduce
distractions and different locations to strengthen the
commands.
Obedience Training on the Leash
Your dog must fully understand the obedience commands
(sit, stay, here, heel, and kennel) before using the e-collar
for reinforcement of these commands. A leash attached
to a standard collar is used to "teach" the dog the basic
obedience commands (sit, stay, here, heel, and kennel).
A tug on the leash/collar is used to reinforce the
command. When the dog complies with the command,
use positive reinforcement/praise. Once the dog
understands these commands, the e-collar can be used to
reinforce them.
Beginning E-Collar Training
When you feel your dog understands the obedience
commands on the leash we can now start with the e-collar
training. With the dog on the leash and wearing the
e-collar, continue with your obedience drills. Apply light
stimulation (Nick or Constant) when a command is given;
the stimulation can be removed as the dog complies.
Through repetition, the dog learns to perform the
command.
The final step is the avoidance phase in which the dog
learns that he can avoid the stimulation altogether
by performing your commands. When these training
procedures are complete, the e-collar is used as a
reminder when the dog does not comply with your