Dogtra 1900X - How to Use the Receiver; Receiver Fitting; How to Insert the Strap

22 23
1. RECEIVER FITTING
Improper Fit
A loose fit can allow the receiver to move around on the
dog’s neck. When this happens, the contact points may
rub against the skin and cause irritation. If the receiver is
too loose, the contact will not be consistent and cause the
corrections to be inconsistent. Dogtra uses medical grade
stainless steel contact points and anti-microbial plastic to
protect the dog’s skin.
Proper Fit
The receiver should be fitted
so that the anti-microbial
plastic contact points press
firmly against the dog's skin.
You should be able to fit two
fingers underneath the collar
strap. The Best location is
on either side of the dog's
windpipe.
HOW TO USE THE RECEIVER
Attention!
Leaving the receiver in the same location on the dog’s neck
for an extended period of time can cause skin irritation due
to the sensitivity from the contact points. If the dog is to
wear the receiver for long periods, occasionally reposition
the receiver every few hours so that the contact points are
moved to a different location on the dog’s neck and remove
the receiver after 8 hours of usage. Make sure you check for
skin irritation each time you use the unit.
2. HOW TO INSERT THE STRAP
1. Insert the strap by looking at the direction of the arrow
on the receiver.
2. Make sure to connect the middle groove of the
receiver. Holds the receiver steady without shaking
3. Attach the receiver to the strap by threading the strap
through the opposite hole.
* Through the * Through the
middle groovemiddle groove