Dolmar ET-110 C - MAINTENANCE INTERVAL; Inspection and Lubrication Schedule; TROUBLESHOOTING; Common Malfunctions and Solutions

14
MAINTENANCE INTERVAL
Parts: Interval: Howto:
Powercord Everytimebeforeusing
Visuallyinspectwhetheritisnotbadlywornor
damaged.Ifitisdamaged,askyourlocalservicecenter
forrepair.
Auxiliaryhandlescrew Everytimebeforeusing
Checkwhetherscrewisnotloose.Tightenthescrewif
itisloose.Replacethescrewifitisdamaged.
Cuttingtoolguard
(protector)
Everytimebeforeusing
Checkwhetherscrewisnotloose,whetherprotectoris
notdamaged.Tightenthescrewifitisloose.Replace
theprotectorifitisdamaged.
Cutterblade Every10h
Lubricatewithanticorrosiveoilaftereachuse.Check
whetheritisnotdamaged.Replaceitifitisdamaged.
Nyloncuttinghead Every10h
Visuallyinspectwhetheritisnotbadlywornor
damaged.Replaceitifitisdamaged.
Gearshaft Every10h Lubricatewithanticorrosiveoil.
TROUBLESHOOTING
Beforeaskingforrepairs,conductyourowninspectionrst.Ifyoundaproblemthatisnotexplainedinthemanual,do
notattempttodismantlethetool.Instead,askDolmarAuthorizedServiceCenters,alwaysusingDolmarreplacement
partsforrepairs.
Malfunctionstatus Cause Action
Motordoesnotrun.
Powermainsisnotpluggedin. Pluginthemains.
Powercablebroken.
Ask your local authorized service
centerforrepair.
The drive system does not work
correctly.
Motorstopsrunningafteralittleuse. Overheating.
Stopusingoftooltoallowittocool
down.
ItdoesnotreachmaximumRPM.
The drive system does not work
correctly.
Ask your local authorized service
centerforrepair.
Cuttingtooldoesnotrotate:
stopthemachineimmediately!
Foreign object such as a branch is
jammedbetweentheguardandthe
cuttingtool.
Removetheforeignobject.
Cutterbladefasteningnutisloose.
Tightenthenutproperlyasdescribed
inthismanual.
Thecutterbladeisbended. Replacethecutterblade.
The drive system does not work
correctly.
Ask your local authorized service
centerforrepair.
Abnormalvibration:
stopthemachineimmediately!
Oneendofthenyloncordhasbeen
broken.
Bumpthenyloncuttingheadagainst
the ground while it is rotating to
causethecordtofeed.
Thecutterbladeisbended,cracked
orworn.
Replacethecutterblade.
Cutterbladefasteningnutisloose.
Tightenthenutproperlyasdescribed
inthismanual.
Cutterbladeisfastenedimproperly.
The drive system does not work
correctly.
Ask your local authorized service
centerforrepair.
Cuttingtoolandmotorcannotstop:
Disconnect the mains plug
immediately!
Electricorelectronicmalfunction.
Disconnectthemains plug and ask
yourlocalauthorizedservicecenter
forrepair.