Dolmar MS-252 - Mounting of Protector

MOUNTING OF PROTECTOR
Tomeettheapplicablesafetyprovisions,onlythetool/protectorcombinationsas
indicated in the table must be used.
Be sure to use genuine DOLMAR cutter blades or nylon cutting head.
Thecutterblademustbewellpolished,freeofcracksorbreakage.Ifthecutter –
bladehitsagainstastoneduringoperation,stoptheengineandchecktheblade
immediately.
Polish or replace the cutter blade every three hours of operation. –
Ifthenyloncuttingheadhitsagainstastoneduringoperation,stoptheengine –
and check the nylon cutting head immediately.
Star Blade Eddy Blade
CAUTION:Theappropriateprotectormustalwaysbeinstalled,foryourownsafety
and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place is not
permitted.
Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2). –
Protector for metal blades Nyloncuttinghead Protector for cord cutter
Whenusingthestringhead,fittheprotector(6)intotheprotector(1),andtighten –
them with two nuts (5) and two screws (4).
11