Dolmar MS-252 - Correct Handling of Machine; Points in Operation and How to Stop

CORRECT HANDLING OF MACHINE
(1)
Attachment of shoulder strap
Adjustthestraplengthsothatthecutterbladewillbekeptparallelwiththe –
ground.
Hanger
POINTS IN OPERATION AND HOW TO STOP
Observe the applicable accident prevention regulations.
Starting
Move at least 3 m away from the place of refuelling. Place the brush cutter on a
clean piece of ground taking care that the cutting tool does not come into contact
withthegroundoranyotherobjects.
Cold start
For machine with U Handle or Loop Handle
Push the I-O switch (1) in the direction shown by the arrow. –
Detachment
Inanemergency,pushthenotches(1)atbothsides,andyoucandetachthe –
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not allow
the machine to be deflected toward you or anyone in the work vicinity.
WARNING:Failuretomaintaincompletecontrolofthemachineatallcouldresultin
seriousbodilyinjuryorDEATH.
First place the machine on the ground. –
Giveagentlepushontheprimerpump(2)repeatedly(7–10times)untilfuel –
comes into the primer pump.
Pushthechokelever(3)totheposition“ –
”.
Firmlyholdtheclutchcasebyyourlefthand,asillustrated. –
Slowly pull the starter grip until resistance is felt and continue with a smart pull. –
Do not pull out the starter rope to its full extent and do not allow the starter handle –
toberetractedwithoutcontrol,butensurethatitisretractedslowly.
Repeat the starting operation until initial ignitions are heard. –
Whentheenginestart,returnthechokeleverto“ –
”.Pleasenotethatthechoke
leverwillreturnto“ ”positionautomaticallywhenthethrottleleverisoperated
and the throttle is opened.
(3)
(2)
14