EasyManua.ls Logo

Dolmar MS-252 - Page 4

Dolmar MS-252
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Start the Brush Cutter/String trimmer only in accordance with the instructions.
Do not use any other methods for starting the engine!
Use the Brush Cutter/String trimmer and the tools only for such applications as
specified.
OnlystarttheBrushCutter/Stringtrimmerengine,aftertheentireassembly
is done. Operation of the device is only permitted after all the appropriate
accessories are attached!
Beforestartingmakesurethatthecuttingtoolhasnocontactwithhardobjects
suchasbranches,stonesetc.asthecuttingtoolwillrevolvewhenstarting.
The engine is to be switched off immediately in case of any engine problems.
Shouldthecuttingtoolhitstonesorotherhardobjects,immediatelyswitchoffthe
engine and inspect the cutting tool.
Inspect the cutting tool at short regular intervals for damage (detection of hairline
cracks by means of tapping-noise test).
Operate the Brush Cutter/String trimmer only with the shoulder strap attached
whichistobesuitablyadjustedbeforeputtingtheBrushCutter/Stringtrimmer
intooperation.Itisessentialtoadjusttheshoulderstrapaccordingtotheuser’s
sizetopreventfatigueoccurringduringuse.Neverholdthecutterwithonehand
during use.
During operation always hold the Brush Cutter/String trimmer with both hands.
Always ensure a safe footing.
Operate the Brush Cutter/String trimmer in such a manner as to avoid inhalation
oftheexhaustgases.Neverruntheengineinenclosedrooms(riskofgas
poisoning). Carbon monoxide is an odorless gas.
Switch off the engine when resting and when leaving the Brush Cutter/ String
trimmerunattended,andplaceitinasafelocationtopreventdangertoothersor
damage to the machine.
NeverputthehotBrushCutter/Stringtrimmerontodrygrassorontoany
combustible materials.
Thecuttingtoolhastobeequippedwithit’sappropriateguard.
Neverrunthecutterwithoutthisguard!
All protective installations and guards supplied with the machine must be used
during operation.
Neveroperatetheenginewithfaultyexhaustmuffler.
Shut off the engine during transport.
Whentransportingtheequipment,alwaysattachthecovertothecuttingblade.
Ensure safe position of the Brush Cutter/String trimmer during car transportation
to avoid fuel leakage.
WhentransportingtheBrushCutter/Stringtrimmer,ensurethatthefueltankis
completely empty.
WhenunloadingtheBrushCutter/Stringtrimmerfromthetruck,neverdropthe
Engine to the ground or this may severely damage the fuel tank.
Exceptincaseofemergency,neverdroporcasttheBrushCutter/Stringtrimmer
to the ground or this may severely damage the Brush Cutter/String trimmer.
Remember to lift the entire equipment from the ground when moving the
equipment. Dragging the fuel tank is highly dangerous and will cause damage
andleakageoffuel,possiblycausingfire.
Iftheequipmentgetsheavyimpactorfall,checktheconditionbeforecontinuing
work. Check the fuel system for fuel leakage and the controls and safety devices
formalfunction.Ifthereisanydamageordoubt,askourauthorizedservicecenter
for the inspection and repair.
Refuelling
Shutofftheengineduringrefuelling,keepawayfromopenflamesanddonot
smoke.
Avoid skin contact with mineral oil products. Do not inhale fuel vapor. Always
wear protective gloves during refuelling. Change and clean protective clothing at
regular intervals.
Take care not to spill either fuel or oil in order to prevent soil contamination
(environmental protection). Clean the Brush Cutter/String trimmer immediately
after fuel has been spilt.
Avoid any fuel contact with your clothing. Change your clothing instantly if fuel
has been spilt on it (to prevent clothing catching fire).
Inspect the fuel cap at regular intervals making sure that it can be securely
fastened and does not leak.
Carefully tighten the fuel tank cap. Change location to start the engine (at least
3 meters away from the place of refuelling).
Neverrefuelinclosedrooms.Fuelvaporsaccumulateatgroundlever(riskof
explosions).
Only transport and store fuel in approved containers. Make sure the fuel stored is
not accessible to children.
Resting•
Transport•
Refuelling•
Maintenance•
Tool Replacement•
3
m
e
t
e
r
s
3 meters
4

Table of Contents

Related product manuals