Safety instructions
2.2 Operating the device safely
e
z Caution – Danger of electrocution!
Do not touch exposed cables with your bare hands. This especially
applies when operating the device from an AC mains.
z Before starting the device, ensure that the power supply line
and the plug are dry.
a
z Do not place any electrical devices inside the cooler.
z Set up the device in a dry location where it is protected against
splashing water.
z Protect the device and the cable against rain and moisture.
z Do not place the device near naked flames or other heat sour-
ces (heaters, direct sunlight, gas ovens etc.)
z Caution! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat generated during normal operation is able to dissipate.
Ensure that the ventilation slots are not covered. Make sure that
the device is sufficiently far away from walls and other objects
so that the air can circulate.
z Never immerse the device in water.
z Do not fill the inner container with ice or fluid.
_CF-18_60.book Seite 30 Donnerstag, 26. Juli 2007 3:18 15
9
To Next Page
Loading...
Need help?
General