Dometic CU402 - Flame Regulation Grill; Electric Hotplate (Depending on Model); Spit (Depending on Model); Turntable (Depending on Model)

4. USE
EN
11
4.5.3 Flame regulation grill
For models CU311 - CU311M - CU333 - CU333M - CU335 - CU335M - FO311:
the grill is to be used only at its maximum capacity.
For all other models:
to regulate flame, turn the knob to the desired cooking flame.
4.6 Electric hotplate (depending on model)
CAUTION
CAUTION
Before turning on the electric hotplate (or if the hotplate has remained unused for a long
time) it is necessary to eliminate any moisture by turning on the hotplate and leaving it on for
30 minutes with the corresponding knob in position 1.
Use pans with flat bottoms and with diameters no less than the diameter of the hotplate.
Dry the bottom of the pan before placing it on top of the hotplate.
When using the hotplate do not leave the appliance unattended and make sure children are
nowhere near the appliance.
The electric hotplate is controlled by a 7-position knob: position off is 0 (zero) whereas positions 1 to 6
are for regulating the hotplate. Positions 1 to 6 correspond to an increase in temperature of the hotplate.
There is a red LED positioned next to the knob which lights up when the hotplate is on.
4.7 Spit (depending on model)
Ignite the oven as described in the chapter 3.4 Oven. Turn the gas knob to the required position. Insert
the drip tray with the spit already installed as illustrated in FIG. 2 - PG. 22. Press the spit button to turn on
the spit motor.
4.8 Turntable (depending on model)
Ignite the oven burner as indicated in chapter 3.4 Oven. Insert the turntable as indicated in FIG. 3 - PG. 22
Press the switch to operate the turntable motor.
4.9 Cleaning
No regular maintenance is required except cleaning.
WARNING
WARNING
Some cooking operations generate a considerable amount of grease. This, combined with
spillage, can became a hazard if allowed to accumulate on the appliance through lack of
cleaning.
CAUTION
CAUTION
Keep the appliance clean and in good working condition. To clean below the hotplate
burners, remove the burner cap screws using a suitable screwdriver. Once the screws are
removed, the burner cap and burner head can be removed to provide access below the
burner. Once cleaned, ensure the burner head and burner cap are refitted. It is recommended
to have it serviced annually by authorized personnel.