Dometic Go Power! 30 AMP RVC MPPT User Manual

gpelectric.com | [page 7]
Maximum Power Point Tracking (MPPT) is an advanced charging technology that more efciently harvests power from solar
panels in all conditions. It does this by continuously tracking the I-V curve of the solar array and modifying operating conditions
to maximize output power. The graph below shows the MPPT point compared to a traditional PWM charger, which always runs
the solar array at a voltage close to the battery voltage.
Due to differences in ambient temperature and light conditions, the maximum power point often changes. The MPPT controller
can adjust parameters according to quickly changing conditions to keep the system near to its maximum working point. The
whole process is fully automatic and does not require any adjustments or interference by users.
The graph below shows how the IV curve of a solar panel changes with varying sunlight conditions.
4. MAXIMUM POWER POINT TECHNOLOGY

Dometic Go Power! 30 AMP RVC MPPT Specifications

General

Battery Voltage Range	8V – 32V
Max Charge Current	30A
Max Panel Input Voltage	100Voc
Max PV Power Input	600W@12V / 1200W@24V
Conversion Efficiency	≤98%
MPPT Tracking Efficiency	>99%
No-Load Loss	<10mA
Grounding	Negative
Max Wire Gauge	8 AWG
Operating Temperature	-35 to 45°C
Storage Temperature	-35 to 75°C
Humidity	95% N.C.
Water Ingress Protection	IP32
Altitude	< 3000m
Battery Type	Lead Acid (AGM, GEL, Flooded), LiFePO4
Protection	Solar/battery reverse polarity Solar/battery over voltage Solar/battery short circuit Over temperature

Weight and Dimensions

Dimensions (H x W x D)	3.15” x 7.78” x 5.5”
Weight	3.14lbs (1.42kg)