Dometic tec 30d ev - Connection to the Exhaust

- 28 - Use, maintenance and installation instructions
TEC 30D EV
GB
CONNECTION TO THE EXHAUST
Proceed as indicated.
1 -Install connection(A) to exhaust manifold (B) and fasten it with special screws.
2 -Connect hose (C) to connection (A) and fasten it with special clamp (D).
3 -Fasten hose to the vehicle floor by means of special damping elements (E).
Important
Comply with the minimum bending range of the flexible tube (see illustration) to
avoid mechanical breakdowns. This precaution is also to ensure that the exhaust gas
can escape correctly.
4 -Set up the muffler (F) on the vehicle’s chassis.
5 -Connect hose (C) to silencer (F) and fasten it with special clamp (G).
Ø>160mm
Exhaust manifold (B)
40200801800.tif
Connection (A)
Clamp (D)
Stay (E)
Hose (C)
Clamp (G)
Muffler (F)