- 42 - Use, maintenance and installation instructions
TEC 30D EV
ALARM MESSAGES
Each time that the equipment’s functioning is irregular an alarm message appears on the
control board display.
Table 7: Alarm list
Alarm Problem Remedy
LOW BATTERY Battery low Change the battery
CHECK OIL LEVEL
Shows that the motor oil level
must be checked
Top up with oil of the same type
OIL CHANGE
Indicates that it is necessary to
change the engine oil
Change the engine oil (See
“Changing engine oil”)
When the equipment is restar-
ted, keep the ON switch pres-
sed for a long time in order to
reset the alarm.
NO FUEL Fuel level too low Fill up with fuel
OIL TEMP PRESS
Insufficient oil in engine Top up with oil of the same type
Motor temperature too high
Switch the appliance off and lea-
ve it to cool. Verify that the air soc-
kets used to cool the equipment
are not obstructed.
If the problem persists, contact
the service department
GENERATOR ALERT! General alarm
See “Finding malfunctions”
If the problem persists, contact
the service department
OVERLOAD!
Requested power higher than 2,5
kW
Decrease the required load
SHORT CIRCUIT Output cable short-ircuit Eliminate the short-circuit
To Next Page
Loading...
