Dometic VARC 72 - Factory Settings: Compressor & Alarms; Compressor Configuration

32
Program/Factory/Factory Settings
Factory Settings
VARC Type None/VARC48/
60/72/96
Compressor Based on VARC type
Refrigerant Based on compressor
Power type 230 V / 16 A
Power set 230 V / 30 A
Set Defaults Yes/No
Control Temp CCW supply/
CCW return
No. of stages #
Electric Heat (EH) Yes/No
Power Cycle Retain Mode/Off
Logo Select appropriate
Background Select appropriate
Flow Switch Yes/No
High Pressure Switch Yes/No
Low Pressure Switch Yes/No
EH Flow Switch* Yes/No
Load Shedding Yes/No
SW Temperature Inlet Yes/No
SW Pump settings
Control By demand/
By unit on
Off Delay # s
CW Pump settings
Flow Prove Delay # s
Off Delay # s
Reversing valve
RV delay time # s
RV toggle time # s
Electric Heat*
Stage Up delay # s
Stage Down delay # s
Compressor
Alarm Retry Setup
Alarm Retry Setup
Temperature Limits
Set Pt.
Off
Band
Retries
Set
Dis
Status
CW High
#.#°C
#.#°F
#/## m
# s
#/## m
CW
Freeze
#.#°C
#.#°F
#/## m
# s
#/## m
Flow Alarm Delay
Delay
Retries
Set
Disable
Status
CW
# s
#/## m
# s
#/## m
Electric
Heat
# s
#/## m
# s
#/## m
High Discharge Pressure
Set point #.# bar
Retrys #/## m
Set Disable # s
Status #/## m
High Pressure Switch
Retrys #/## m
Set Disable # s
Status #/## m
Low Suction Pressure
Cool Set Point #.# bar
Heat Set Point #.# bar
Compressor
Econo mode SW Yes/No
Minimum On # s
Minimum Off # s
Min Time between Starts # s
Load Up Time # s
Frost Protection
Condenser Setpoint #.#°F
Condenser Band #.#°F
Compressor Speed #.# rps
Control Direct/Reverse/Both
P/PID/P+I
K #.#
Minimum #
Maximum #
DBd #.#
Out #