OPERATION
EPT019297 Issue 1 November 2016 4-67
24 Gutter Dry at Start-up The printer was not shut down correctly.
Clean the print head, see page 5-17 and restart the
printer.
Blocked nozzle.
Runt the nozzle unblocking wizard, see page 5-18.
Dried ink in the gutter.
Clean the print head, see page 5-17 and restart the
printer.
Ink jet incorrectly aligned.
Check the ink jet alignment, see page 5-19.
25 Add make-up cartridge A new make-up cartridge is required.
Fit a new make-up cartridge, see page 5-4.
41 Ink level too high the ink viscosity has increased and extra make-up
has been added to the ink causing the level to
increase.
Replace the ITM, see page 5-10.
Frequent flushing has occurred, either due to
repeated start/stop, repeated flushing or cleaning
of the print head.
Avoid frequent start/stop and shut down the printer
before cleaning the print head.
The printer has been moved to a different location
with the ink and make-up cartridges fitted.
Shut down the printer and remove the ink and
make-up cartridges before moving the printer.
53 Make-up Level Below
Minimum
The make-up level is running low.
Fit a new make-up cartridge, see page 5-4.
134 Unexpected shutdown The printer was not powered off using the correct
method.
Follow the correct shut down procedure, see
page 4-17.
Alert ID Description Possible Cause and Remedy
To Next Page
Loading...
Need help?
General
