EPT058613 Issue 1 March 2020 21
SWITCHING ON AND OFF
WARNINGS: (1) The laser marking system must only be used for its intended
purpose.
(2) The laser marking system may only be operated by personnel
trained to do so by Domino.
(3) Operation is only allowed with all required cables connected
and all parts mounted. Do not disconnect any cables during
operation.
CAUTION: The lens cap must be removed before operation.
Switching On the Control Unit
At the controller, release the On/Off button by turning it clockwise. Wait until the SERVER
RUNNING indicator has illuminated.
Switching On the Laser Head
Turn the key switch from position “0” to position “1”. To start the laser turn the key
clockwise to the laser symbol and hold it for at least 1 second. The key automatically turns
back to position “1”.
• The laser needs a warm-up phase of 3 seconds.
The PRINTER BUSY indicator will illuminate when the laser hardware is switched
on.
The PRINTER READY indicator illuminates. After initialising the Dynamark 3 software
and starting the lasers, the marking system is ready.
Laser emission is also displayed by a red LED on the rear of the laser unit.
Switching Off the Laser Head
Turn the key switch from position “1” to position “0”. The laser hardware is switched off.
Switching Off the Control Unit
Press the On/Off button at the controller. The computer will immediately switch off.
To Next Page
Loading...