Domino F520i

EPT058613 Issue 1 March 2020 7
HEALTH AND SAFETY
GENERAL
The F-Series laser marking systems are designed and built in accordance with international
standards and other technical specifications, which are to be observed. The equipment
conforms to current technology and approved safety requirements.
Domino F-Series laser marking systems are produced by Domino Group company; Domino
Laser GmbH Germany. For Sales and support, contact Domino.
This safety standard, however, can only be achieved if all intended and required measures
have been taken and are constantly observed. It is part of the equipment operator’s duties
to plan these measures and check their continuing implementation.
The F-Series laser marking systems have been developed and designed for fully automated
marking of packaging materials and products by use of laser radiation.
The user must ensure that:
• The laser system is only made ready for use after it has been installed and
guarded to Class 1 laser safety standards (EN60825)
• The equipment is only to be used for its intended purpose
• The equipment is only operated in a good, serviceable condition, and that all
safety installations are regularly checked for their serviceability
• Personal protective goggles for maintenance and repair personnel are required
and made available
• Only suitable and approved tools and equipment are used
• The product manual is complete and in a legible condition at the equipment
location at all times
• The valid rules and laws regarding accident prevention are available and
observed
• Only sufficiently qualified and authorised personnel shall operate, maintain, and
repair the laser marking system
• These personnel are regularly instructed in all matters concerning appropriate
labour safety and environmental protection, and that they are familiar with the
product manual, particularly the safety instructions contained therein
• Any safety and warning signs on the laser marking system must not be
removed and must remain in a readable condition.
SPECIFIC DANGERS
Electrical Energy
In the F-Series laser marking system, the maximum operating voltage is the connected
mains voltage, which can pose a hazard to health. The mains voltage to be maintained is
shown on the name plate.
Work on live components must only be performed by authorised personnel.
In the case of a defective power supply, operation of the laser marking system is to be
stopped immediately and is only to be repaired by authorised personnel.
Keep the control unit closed at all times. Only expressly authorised personnel are permitted
to open the control unit.