Domino F520i

EPT058613 Issue 1 March 2020 41
FAULT FINDING
SYSTEM STATUS MESSAGES
Status Message Cause Suggested Action
11
Encoder/Line too fast
(overflow).
The message has not been
completed in time.
Slow down the conveyor, reduce the
mark time, or move the text upstream
on the field.
12
Encoder/Line too
slow (underflow.)
The message has not been
completed in time.
Reduce the mark time or move the text
upstream on the field.
13
List buffer repeat
count fail.
Internal Fault. Restart the system. Contact Domino.
14
Maximum print to
print distance
exceeded.
The maximum distance
between print go signals has
been exceeded and an
expected print go was not
received.
Restart the system. Contact Domino.
15
Print start signal
ignored.
A print go has been received
too soon after the previous.
Restart the system. Contact Domino.
16
Maximum laser on
time exceed (laser
disabled by
hardware).
The laser has been firing for
longer than expected.
Restart the system. Contact Domino.
17
Laser warm up. A short warm up period is
required before use.
Restart the system. Contact Domino.
30
Scanhead power
missing.
There is no +/-15v at the
scanhead, or no data returning
from scanhead.
Restart the system. Contact Domino.
31
Scanhead
temperature out of
valid range.
The scanhead is cold. Restart the system. Contact Domino.
32
Scanhead warming
up -please wait.
The scanhead is cold. Wait for the heaters in the scanner
motors to warm the scanners, the
printer can be used but you may
experience very minor position errors.
33
Control unit over
temperature.
The temperature in the
controller is very cold or too hot.
Check that the fans are working and
that the filters are not blocked.
51
Control unit near over
temperature.
The controller is getting quite
hot.
Check that the fans are working and
that the filters are not blocked.
56
Printer ready to print. Printer will print if a print go
signal arrives.
Information Only.
58
No Message loaded There is no valid message
loaded into the controller.
Load a message and send it to printer.