24 of 27 PSS5000/INGU/805799/09
PSS 5000 – Installation Guide
4 Technical Data
Electrical data
The electrical parameters of the PSS 5000 have the following values:
Electrical
Recommendation: supplied power uses the same Mains phase as:
• POS (Point Of Sale)
• BOS (Back Office System)
• Forecourt devices (electronics for dispensers, terminals, tank gauges, etc.)
The Mains cable must be installed according to the local regulations. The Mains
power to the PSS 5000 is switched off by removing the Mains cable.
230 V version
Mains power voltage (max.)
Mains power voltage (min.)
Mains power frequency
Standard power supply:
Max. power consumption
Fuse, 5 x 20mm, slow blow
Dual Trafo power supply:
Max. power consumption
Fuse, 5 x 20mm, slow blow
230 VAC +10% = 253 VAC
230 VAC – 15% = 195 VAC
50 Hz/60 Hz
43 VA
T400mA
55 VA
T630mA
120 V version
Mains power voltage (max.)
Mains power voltage (min.)
Mains power frequency
Max. power consumption
Fuse, 5 x 20mm, slow blow
120 VAC +10% = 132 VAC
120 VAC – 15% = 102 VAC
50 Hz/60 Hz
43 VA
T1A
To Next Page
Loading...
Need help?
General
