Propeller Shaft
PR-7
3.Eliminate the clearance between bearing and snap ring
by knocking flange fork.
4.Check the flexibility and axial freedom of the spider
shaft.
Maintain
Replace of the front oil seal
Note:
The adjusted spacer is used for the driveline. After
the disassembly of the flange, it is necessary to adjust the
pretightening force of the bearing, so the main retarder
needs to be repaired.
1.Remove the propeller shaft.
2.Loose the end face nut.
3.Remove the connecting flange.
4.Remove the front oil seal.
To Next Page
Loading...