Propeller Shaft
PR-8
5.Apply some grease on the lip cavity of the oil seal and
then press it into the oil seal seat.
6.Assemble the flange disc and drive gear nut.
7.Assembly the propeller shaft.
Disassembly and Assembly
Disassemble
Remove the propeller shaft.
After removing the propeller shaft, plug the output port of the transmission by plug.
Remove the axle housing half axle.
Note:
Don't damage the spline, sleeve flange fork and
front oil seal when removing the propeller shaft.
Assemble
Fill with recommended gear lubricant.
To Next Page
Loading...