Suspension
SP-6
5.Slowly down the jack to fall the rear axle to the ground,
and remove the sub leaf spring assembly and sub-leaf
spring underplate;
6.Disassemble the the rear end of the the leaf spring.
Remove the fasten bolt of the leaf spring pin and pull the
spring pin out then you can disassemble the rear end of
the leaf spring rear end;
Note: When pulling the spring pin, you must use the
the threaded sleeve of the spring pin. Before remove the
lock bolt of the leaf spring pin, screw the threaded sleeve
off a little then pull, or you can use the pin puller with
thread.
7.Remove the cotter pin used to fix the front pin of the rear
leaf spring, then take down the front pin of the rear leaf
spring, down the jack then remove the rear leaf spring
finally;
8.Take down the cotter pin of the lifting eye pin, and make
use of an iron rod(diameter=15mm) went through the
special hole used to remove the lifting eye pin, then push
the pin out to take down the lifting eye.
Disassembly of the front and rear leaf spring
1.Take down the clamp;
2.Clamp the center part of the leaf spring by a C-shape clip;
3.Take down the center bolt;
4.Loose the C-shape clip slowly and detach the spring leaf.
To Next Page
Loading...