10 11www.donperusa.com Phone: (844) 366-7371 Email: sales@donperusa.com
UNPACKING
3. Inspect for damage immediately upon unpacking and call Donper USA Technical
Service if you discover any damaged or missing parts.
4. Clean and properly lubricate machine parts prior to machine operation.
A er unpacking and inspecting the parts, you are ready to disassemble the machine
and prepare for the rst operation.
PRIOR TO OPERATING
A er you have unpacked and set up your machine for use, we recommend running
the “CLEAN” cycle for a few minutes with a mixture of 1-table spoon of bleach per
gallon of water to ensure sanitization. Fill the freezing cylinder and hopper with this
mixture then run “CLEAN” cycle for about 2 minutes. Dispense the water and repeat
for best results.
For more information please visit our website www.donperusa.com for instructional
videos on how to adjust this setting.
M R:
For optimal machine performance and many years of e ciency and reliability from
your machine, Donper USA recommends cleaning and sanitizing the machine and
its parts daily.
• REPLACE WEARABLE PARTS Every 1 to 3 months
• PREVENTATIVE MAINTENANCE Every 3 Months
CAUTION
1. Do NOT run the machine without properly lubricating required parts
2. Do NOT clean the machine with abrasive or toxic chemicals and cleaners. Do-
ing so may cause damage to the stainless steel material
3. NEVER use metal objects to clean the machine
4. ALWAYS replace wearable parts a minimum of every 3 months
5. ALWAYS inspect parts for excess wear and damage
To Next Page
Loading...
