43
1800-060 Issued 7-19
Version A
1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep heard).
Note: the number of rings before the system answers is dependent on the programming in section 3.1.8.
2. Press
*
36 for FOUR-digit entry code time zones, or
*
37 for FIVE-digit entry code time zones, then enter the four-digit
MASTER CODE (beep heard).
3. Press 0
*
(beep heard) to turn the time zone OFF, or press 1
*
(beep heard) to turn the time zone ON.
3. Hang up the phone or if at the system keypad, press 0 # together (beeeeeep).
1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep heard).
Note: the number of rings before the system answers is dependent on the programming in section 3.1.8.
2. Press
*
35 and enter the four-digit MASTER CODE (beep heard).
3. Enter the single-digit time zone number that you want to turn OFF or ON, then press
*
(beep heard).
Note: Refer to section 3.4 to determine which time zones have been programmed into the system or see log tables in back of
this manual.
4. Press 0
*
(beep heard) to turn the time zone OFF, or press 1
*
(beep heard) to turn the time zone ON.
5. Hang up the phone or if at the system keypad, press 0 # together (beeeeeep).
The entry code time zones can be turned OFF (disable) or ON (enable) remotely
from a touch-tone telephone at any time without changing the time zone
boundaries. To program the time zone boundaries, see sections 3.4.3 and 3.4.4.
Entry code time zones can also be turned off or on at the system keypad by
skipping step 1 and proceeding directly to step 2 in the sequence below.
The four time zones that automatically activate and deactivate the relays can be turned OFF (disable) or ON (enable) remotely
from a touch-tone telephone at any time without changing the time zone programming. To program the automatic relay activa-
tion time zones, see section 3.4.2. The four Automatic relay time zones can also be turned off or on at the system keypad by
skipping step 1 and proceeding directly to step 2 in the sequence below.
4.2.4 Remote Entry Code Time Zone Enable / Disable
4.2.5 Remote Automatic Relay Time Zone Enable / Disable
4.2 System Administrator Continued
To Next Page
Loading...
